STEP 1 PREPARE and WET SKIN
Prepare & wet skin
Always wet/rinse your skin with warm water, so that the lotion of the bar is applied to a wet surface;
An important step is to ensure the oils etc in the Regenassist Skin Treatment bar are formed into a emulsion - a creamy rich lotion. This is achieved by rubbing the hands together vigorously, after a lather is formed in the hands from the wet Regenassist Skin Treatment Bar apply to the area requiring treatment.
Once an even distribution of the lotion is achieved (to look like a pale/white mask), then it should be left alone for 2 to 3 minutes, then rinse and leave your skin wet ready to apply step 2.
STEP 2 PREPARE THE MASK
Prepare the mask
Dispense a large grape sized amount of Mask into a small mixing bowl. Mix in small amounts of purified water until a light creamy texture is achieved. The ideal consistency should resemble creamy yoghurt, and hold on to the end of a brush.
STEP 3 APPLY THICK COVERAGE
Apply thick coverage of mask
Using a flat blade style paint brush, spatula, or finger, apply the mixed Mask to a moist skin that has been prepared using the RegenAssist Peptide Skin Treatment Bar and left wet. The best technique is to place dobs of Mask on the skin and gently spread it, rather than attempting to paint it on. Care should be taken to ensure a thick coverage is achieved, with no patches of skin visible through the Mask.
STEP 4 LEAVE ON 6 MINUTES
Leave-on treatment (6 minutes)
Once an even coverage of the desired area is achieved, leave Mask on for 6 minutes.
Absorption Analysis
During the 6 minutes, carefully observe the drying of the Mask on the face. Determine the rate of absorption in particular areas as noted on our facial analysis chart.
It is important to ensure that the Mask never dries during this time, as the Mask ceases to be active once dried. Wet dry areas, as they appear, using a spray bottle of water or a wet sponge.
STEP 5 FACE ANALYSIS
FACE ANALYSIS
The face is made up of zones that correspond to specific areas of the body. Imbalances and dysfunctions in this area will drain energy from the corresponding zone.
A holistic approach is the only effective solution - combining Nutrition and Skin Treatments.
Learning how to read your face gives you control and power over your complexion which equals CONFIDENCE.
Book one with our Regenassist demonstrators.
STEP 6 RINSE AFTER 6 MINITES
Rinse immediately
Once 6 minutes has passed, gently rinse off the mask with warm water, as the benefit of leaving the Mask on diminishes with each additional minute. Gently towel dry.
Where possible, retain water used to rinse off Mask for use as a Foot Bath, and/or to pour over plants and vegetables.
Intense Treatments & Trouble Spots
For intense treatments, increase the frequency, and apply a thicker layer of Mask. Mask can be effectively applied to small areas for concentrated and frequent application. However, it is recommended that every third application should be a Mask covering the entire face.
